LOGO.pro
With one-sided formwork anchor system
- Tie-points can be operated by one person/fully operable from one side
- Time and cost savings for long straight walls
- Depending on requirements, the system can be anchored either on one side or conventionally (two-sided)
- Compatible with LOGO.3 and LOGO alu
- Use of standard tie rods and therefore no expensive special tension bars required
- No time-consuming staking of the anchor bars
- Tubes are freely selectable
- Orderly joints and anchors with visually appealing concrete surfaces
- Well-balanced sorting of panels
The innovative formwork solution LOGO.pro can be anchored either from just one side or in the conventional manner.
| Technical Data | |
|---|---|
| Panel widths | 240/90/60/45/30 cm |
| Panel heights | 340/270 cm |
| Frame depth | 12 cm |
| Plywood | 16 mm thick, 12-ply Finnish birch plywood |
| Frame | Profiled flat steel frame of high-strength steel |
| Outside corner post | Side length 50 cm |
| Inside corner post | Side length 25 cm |
| Plastic filler pieces | Widths 5/6 cm with openings for ties, Widths 1/2/3/4 cm without openings for ties |
| Max. concrete pressure | 70kN/m² according DIN 18218 |
| Tolerances of deflection | According DIN 18202, table 3, line 6 |
Request Documentation Request a Quote
Order online now
